<div dir="ltr"><div><div><div><div><div><div><div><div>Hi there,<br><br></div>i have problems figuring out how X-ray derived PDF should be correctly inputted into RMCProfile.<br><br></div>On page 157 in the RMCProfile manual it is written that the X-ray G(r) needs to be normalised so that it is scaled from 0 to 1. This is exactly the format i have. However, if I init my calculation and plot the "PDFs of rmc fit" using rmcplot it has an offset (please see the attached figure "<a href="http://gr_without_offset.ps">gr_without_offset.ps</a>")<br><br></div>It is clear, that the RMC fit is actually normalized to 0 when going into infinity.<br><br></div>I thought, this might just a result by subtracting 1 from the previously 0 to 1 normalized G(r). But after several iterations using an offset of -1 it became clear that low part is not normlized to -1. (see the "gr_with_offset" figure attached).<br><br></div>In the manual it is also written that G(r) goes from -(sum c_j b_j)² to 0. But for X-ray this does not make sense due to q-dependent form factors...<br><br></div>Can you please explain me how i should transform my data?<br><br></div>Best wishes,<br></div>Clemens<br></div>